Ireland Farm Equipment

  • 4802 50 St
  • Vermilion, AB T9X 1M3
  • Call Us: (780) 853-4013
  • https://irelandfarm.ca/
Print This Page

2021 Kello-Bilt 275DR 7S

Information

2021 Kello-Bilt 275DR 7S

Model 275DR

This model features a heavy duty ripper shanks with adjustable trip and lift/drop reset that will not weaken over time.

The Benefit of Kello-Bilt Products
  • Oil Bath Bearing: Features back-to-back tapered roller bearings, operating in 90W gear oil and sealed with Duo-Cone TM seals.
  • Welded Spacer Spool: Fabricated steel spacer spools, which will not shatter nor compress, provide maximum durability in the toughest conditions.
  • Gang Shafts & End Washers: Made of high carbon alloy steel to eliminate stretch and premature failure.
  • Bearing Standards & Wear Plates: Consisting of a minimum thickness of 3/8" rectangular tubing for maximum support.
  • Gang Bar: Fabricated as a single weldment for maximum stability, with no U-bolts to stretch and loosen that can cause loose disc assemblies or bearing failures.
Features may include:
  • 6" x 6" x 3/8" high strength steel tubing, fully welded and reinforced.
  • Oil bath, back to back timken tapered roller bearings in heavy ductile cast. Bearing comes complete with wear plate.
  • 2-1/8" heat treated high strength alloy steel, threaded on both ends.
  • 10-1/2" spacing, welded heavy duty spacer spool.
  • Comes with four 11L x 15 (load range D) highway implement tires mounted on 8 bolt hub assemblies.
  • Heavy duty adjustable mechanical trip. Replaceable reversible chisel points. Three working depths to 18' maximum. Shank spacing - 30 inches.
  • Two 5" x 8" hydraulic cylinder complete with hoses, depth control segments and cylinder transport lock.
  • 7,000 lb hitch jack, plated grade 8 fasteners, gang wrench (2) and separate fore/aft and transport level controls.

Photos

Highlights

  • Vermilion, Alberta
  • 2021
  • Kello-Bilt
  • 275DR 7S
  • Available
  • Cut: 19' (5.79 m)

Specifications

  • 2021
  • Kello-Bilt
  • 275DR
  • 7S
  • Disc Bedders/Harrows
  • Suggested Drawbar Horsepower: 300+
  • Cut: 19' (5.79 m)
  • 16' 9" (5.10 m)
  • 13,100 lb. (5,942 kg)
  • No. of Shanks: 7